![]() ![]() Keep the area wet as this will prevent the glass from overheating and cracking, and also preserves your drill bit. Hold the drill and place the bit on the surface of the glass at a 45-degree angle. Put a thin circle of clay about an inch from where you will be drilling. Then, set the glass down on it and use rubber clamps to hold it in place. Position the GlassĬushion the plywood with newspaper or an old cloth. The speed should be set to 250 RPM for a 2-inch long bit, and 160 RPM if it is longer than that. Insert the bit into the chuck and set the variable speed to 800 RPM if the bit is a half-inch long, or 500 RPM if the bit is an inch long. ![]() The longer the drill bit, the slower the drill should be. This has a hollow body and cuts through the glass, leaving a wide-diameter hole. You will need a specialist diamond drill bit such as a diamond-coated tile and glass bit. You should think carefully before attempting to drill a hole through it. Tempered glass is heat-treated and very dense, so it has a much higher risk of shattering. Put on your protective goggles and face mask. You are going to start with a small starter hole and then make it larger. Prepare the Drillįit a one-eighth-inch carbide or diamond-tipped spear point drill bit into your power drill’s chuck. Use a felt-tip pen to mark the exact spot where you want to drill. Then, place two strips of masking tape in an X shape over the spot on the glass where you want the hole. Line a piece of plywood with newspaper or an old sheet to add some cushioning. A spear-tipped carbide or diamond-tipped drill bit.Drilling glass is a delicate job, so make sure you have the following items before you start: What Type of Drill Bit Do You Use for Glass?Īs with any DIY task, it is important to have the necessary equipment.Can you Drill Through Glass Without Breaking It?.How to Drill a Hole Through Tempered Glass. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |